Get the latest bios, put it on a flash drive and insert it into the boards designated USB slot. Other thought, if the system is telling you flash the bios, you may have just gotten 2 boards with the same buggy bios, that happens very frequently.įortunately with Asus the Flashback Procedure is pretty good. I would certainly get yourself a 99c mainboard speaker, then we could at least get some feedback from the board. Sorry, I am coming in late here, since it wont post its hard to get any kind of feedback. So, any ideas? I literally can't think of anything else to try.nothing but dead ends. Uninstalled the AIO and cpu to make sure there were no bent pins. Tried 3 different monitors, both hdmi and DVI on the rx580 Triple checked power supply cable connections on everything. Tried 2 different psu's, Phanteks AMP 750w and Enermax 650w. Tried each set with one stick at a time in each slot individually Tried 3 different sets of DDR4, Ballistix Elite 4000, TridentZ 3600 and Mushkin Redline 4000. Cleared cmos twice by removing the battery for 15 minutes each time All components were verified working with a Gigabyte z590 as of yesterday. Original system specs Asus z590, Intel 10600k, rx580, WD Black M.2, Gskill Trident Z RGB 3600, Phanteks AMP 750w psu. Before you make suggestions, these are the steps I've already taken: It's never posted out of the box., I'm desperate for suggestions before I give up and return the board. From the very first attempt, the fans turn on, the AIO pump turns on, The Q-LED goes from quick red then gets hung for a few seconds on Dram and the light just goes away, never even lights up the gpu light. Anyways, I just can't figure this out, and I've tried every troubleshooting step I've ever known to try to make it work. OK, so I have a brand new Asus Tuf Gaming z590 Plus wifi that I bought to replace a Gigabyte z590 that I returned because it hated clocking memory over 3600.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |